Friday, December 5, 2014

Walnut Dining Trestle Table: Legs Part 2


This about where we left off on the legs.


Cutting this bridal joint is fun and exacting all at the same time.  You can see the kerfs I use to relieve the waste.  The final removal can be done via chisel or a bandsaw.  Layout marks indicate orientation.  Cross grain cuts are all knifed to score fibers.


 The leg assemblies are joined via a centrally located stretcher that sits in a thru tenon cut into the upright of each leg.  Here is the layout,

The corresponding tenon is cut using a router and router board, here we are sizing the tenon:

Its easy to resolve to beating this joint together but far more productive to slowly work on the fit, there is no hiding a sloppy fit on a thru tenon:




Friday, November 14, 2014

Walnut Dining Trestle Table: Legs Part 1



This table is all about the legs.  So thats where we start:


Sizing the blanks for the feet on the bandsaw


No 16/4 Walnut handy, so these are face laminations of 8/4 stock.

The foot features a colossal M/T joint where the upright meets the foot, I like to start with the mortise. If I can get a nice mortise cut with parallel walls, I find it easier to size the tenon.  

I hog these out on the slot mortiser , adjusting the z-axis as I go:

Put the upright right on the foot and pull your measurements directly.  This is a simple joint to cut. I am comfortable running the upright on the TS and finishing off with a sharp X-Cut handsaw.

With the bottom joint fitting properly we move to the bridle joint at the top attaching the upright to the upper support where the top will rest.  Again work piece to piece using centerlines always to line up and do the layout.

Its easy to miscut this joint because you are only removing half of the material from either member.  I chose to kerf the waste and finish up on the bandsaw.
























Tuesday, September 9, 2014

Walnut Dining Trestle Table: Preview



coming soon....a generous 8 foot trestle table in walnut



Pulling out all the stops

- M&T joinery
- drawbored joints
- breadboard ends
- 8/4 material





Thursday, August 14, 2014



A few shots of the completed Maze Bookcase Project




Tuesday, July 8, 2014

Maze Bookcase: Joinery


I had a few questions posted about how these bookcases came together and decided I would reveal a bit more about what was going on:



These bookcases feature cantilevered shelves from the left and right sides.  Shelves like this are always a challenge because of the physics involved in supporting something from its endpoint. I settled on a tight dado, reinforced with loose tenons to keep the shelf from sagging and prevent it from being levered away from the side.


The central divider with horizontal shelves is assembled with a modified cross lap joint:


you can see the shallow dado that gives the cross lap even more strength and cleans up the intersection of the shelf with the upright.

The top and bottom are all attached to the side and upright with loose tenons.

Wednesday, May 21, 2014

Maze Bookcase Project



Thought I might check in here with a new client project:


There are numerous parts, and prep for finish has begun.



I will post some joinery details soon.

Wednesday, February 19, 2014

White Oak Console Table: Finish



A simple shaker inspired table like this is a great candidate for an oil varnish blend, but the ambered tone of oak furniture has been maligned by the mass production ubiquity of cheap oak kitchen cabinetry.  The client wanted the look of  raw white oak (as if it had just been sanded) that did not have the orange tones of an oil/varnish.

I shot the table with a matte clear conversion varnish.  The finish is a catalyzed product that is water white, incredibly tough, and comes in a flat 10 sheen.